![]() there will be no visible scar (even without any retraction and coasting and wipe) as cura will print that cylinder in a single screw move while S3D will have layers. ago So it looks normal when in the default view but disappears when you go to preview print S3D has done that to me when the parts are too thin/small. cura does), so if you don't have your retraction, coasting and wipe setup perfectly and you use semitransparent filament there will be a visible scar on the print when using S3D while with Cura for e.g. 1 17 17 comments Best Add a Comment intrglctcrevfnk 5 yr. Im trying to print the attached model from thingiverse, but for some reason the preview (and the print itself) is different than the model. It still have a "z move once per layer" instead of a constant smooth Z move troughout the object having no layers (like for e.g. Some overhangs were fixed but not all of. I also tried making the STL file into a single mesh with minimal success. ![]() I am attaching a picture of what it looks like in Simplif圓Ds preview. Enabling 'merge all outlines into a single solid model' does not fix either. Now, that was already said by dkightley, I'm only writing to add that S3D does not properly does the "screw mode" neither in that case. They show up as non-manifold edges where they connect and I have them set to heal. ) then you select a screw mode and how many bottom layers you want and 0 top layers and you will get a single wall extrusion pipe you expected. ![]() Have a cylinder with a wall thickness of my extrude width, have vase mode checkedĪs dkightley said you need to use a real cylinder, not a pipe (what you are describing is a pipe, you need a cylinder that's closed top, bottom.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |